Take note of this. Press the down arrow to advance to the next Thermostat Node ID. Now name the thermostat and select correct location of the thermostat from the menu. Help is available via support links on the above site. If Z-Wave thermostats are part of the system, the Node ID for the thermostat must be associated mapped with the specified thermostat address in the Leviton controller. 
| Uploader: | Kacage |
| Date Added: | 4 June 2018 |
| File Size: | 44.3 Mb |
| Operating Systems: | Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X |
| Downloads: | 96387 |
| Price: | Free* [*Free Regsitration Required] |
Highlight the thermostat to be associated and press the center button. Continue steps until all buttons on all scene controllers have been programmed.
Drilling the hole for the deadbolt, allowing it to extend to a fully locked position will resolve the problem. The systems must be utilizing controller firmware 3.
The hole for the deadbolt has not been drilled deep enough, preventing the deadbolt from fully extending in the lock position.
RF Installer Tool
This will only recover powered in-wall devices, any battery powered devices will have to be re-enrolled individually. Write the PC Access configuration to the automation controller. Apply power to the thermostat. Press the center button to begin the enrolling process.
The House Code defines the lighting protocol that is used cizia groups of lights. Press Ok when finished. The controller has the correct firmware 3.
Click on the Command button, then select Control. Press the center button. Enter 0 if there is no node associated to the specified unit number.
This will set up the mesh. Press OK when Finished. Highlight the node ID of the device to be associated and press the center button. Highlight the correct scene controller then select scene. You should get normal status feedback from all devices.
RF Installer Tool
Set a serial port to Leviton Vizia b. Now name the thermostat and select correct location of the thermostat tokl the menu. Press ' ' to change the module type, then use the arrow keys to select the proper module type, then press ' ' to enter: Finally write the configuration to the controller.
The purpose of this document is to provide general steps for enrolling Leviton Vizia products into a network for your knowledge. In this scenario, the lock will always report its status as unlocked. From the drop down box, select the correct scene, and then press OK. Have them default the VRC0P and one of the switches, and enroll them in a separate network and if that switch reports status the rest of the network will need to be defaulted and re-added as well.
Highlight the switch to be associated and press the center button. Press the center button on the controller to begin the enrolling process. All the locks are looking for is the exclusion signal, so you do not need the actual network file to exclude a lock.
Help is available via support links on the above site. This will pop up a window that requests the Home ID of the network you wish to recover, enter the Home ID from the bottom of the page. Set the desired House Codes to Vizia for lighting. Leviton Omni and Lumina family controllers support two-way integration with Z-Wave wireless locks. Then save the settings.
Comments
Post a Comment